Dell Force10 S4820T FTOS Command Reference Guide - Page 151

Defaults Command Modes Command History Usage Information ipv6-address outgoing-interfa ce Enter the IPv6 address, in the x:x:x:x::x format, to which you are testing connectivity. Note: The :: notation specifies successive hexadecimal fields of zeros (IPv6 link-local address) Enter one of the following types of outgoing interface for traceroute packets to a destination link-local address. • For an 100/1000 Ethernet interface, enter the keyword gigabitethernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword tengigabitethernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094.followed by the slot/port information. • For a Management Ethernet interface, enter the keyword management ethernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by the slot/port information. Timeout = 5 seconds; Probe count = 3; 30 hops max; 40 byte packet size; UDP port = 33434 EXEC EXEC Privilege Version 8.3.19.0 Added support in the outgoing-interface parameter for link-local IPv6 addressing on the S4820T. Version 8.3.12.0 Added support in the outgoing-interface parameter for link-local IPv6 addressing on the S4810. Version 8.4.1.0 IPv6 tracerouting available on management interface. Version 8.2.1.0 Introduced on E-Series ExaScale with IPv6 Version 8.1.1.0 Introduced on E-Series ExaScale (IPv4 only) Version 7.9.1.0 Introduced VRF. Version 7.6.1.0 Added support for S-Series Version 7.5.1.0 Introduced on C-Series Version 7.4.1.0 Added support for IPv6 address on E-Series E-Series original Command When you enter the traceroute command without specifying an IP address (Extended Traceroute), you are prompted for a target and source IP address, timeout in seconds (default is 5), a probe count (default is 3), minimum TTL (default is 1), maximum TTL (default is 30), and port number (default is 33434). To keep the default setting for those parameters, press the ENTER key. For the source IP address option, you may enter IPv6 global addresses only (link-local addresses are not supported). Control and Monitoring | 151