Dell Force10 S4820T FTOS Command Reference Guide - Page 1213

Usage Information On 40-port 10G linecards, if the traffic is shaped between 64 and 1000kbs, for some values the shaped rate is much less than the value configured. Do not use values in this range for 10G interfaces. Related Commands rate-shape Shape traffic output as part of the designated policy. service-class dot1p-mapping Map the service class dot1p value to a CoS queue value. Syntax service-class dot1p-mapping {dot1p0 value | dot1p1 value | dot1p2 value | dot1p3 value | dot1p4 value| dot1p5 value | dot1p6 value | dot1p7 value} Parameters dot1p value Enter the keyword dot1p value followed by the CoS queue value that will be mapped. dot1p Range: 0 to 7. CoS queue value Range 0 to 3. Defaults For each dot1p Priority, the default CoS queue value is shown below: dot1p Priority CoS Queue 01234567 00012333 Command Modes CONFIGURATION Command History Version 8.3.19.0 Version 8.3.12.0 Version 8.3.16.0 Introduced on S4820T Introduced on the S4810. Introduced on MXL 10/40GbE Switch IO Module Related Commands show qos dot1p-queue-mapping Displays the dot1p priority to queue mapping on the switch. Usage To apply dot1p-queue-mapping, use the service-class dynamic dot1p command. Information service-class dynamic dot1p c e s Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes INTERFACE mode entries. Syntax service-class dynamic dot1p Quality of Service (QoS) | 1213