Dell Force10 S4820T FTOS Command Reference Guide - Page 197

Related Commands The C-Series and S-Series cannot count both packets and bytes, so when you enter the count byte options, only bytes are incremented. Note: When ACL logging and byte counters are configured simultaneously, byte counters may display an incorrect value. Configure packet counters with logging instead. ip access-list standard permit Configure a standard ACL. Configure a permit filter. ip access-list standard c e s Create a standard IP access list (IP ACL) to filter based on IP address. Syntax Parameters Defaults Command Modes Command History Usage Information Example ip access-list standard access-list-name access-list-name Enter a string up to 140 characters long as the ACL name. All IP access lists contain an implicit "deny any," that is, if no match occurs, the packet is dropped. CONFIGURATION Version 8.3.19.0 Version 8.3.10.0 Version 8.1.1.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 Version 6.5.1.0 Introduced on S4820T Introduced on S4810 Introduced on E-Series ExaScale Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Added support for S-Series Added support for C-Series Added support for non-contiguous mask and added the monitor option. Expanded to include the optional QoS order priority for the ACL entry. FTOS supports one ingress and one egress IP ACL per interface. Prior to 7.8.1.0, names are up to 16 characters long. The number of entries allowed per ACL is hardware-dependent. Refer to your line card documentation for detailed specification on entries allowed per ACL. FTOS(conf)#ip access-list standard TestList FTOS(config-std-nacl)# Access Control Lists (ACL) | 197