Dell Force10 S4820T FTOS Command Reference Guide - Page 1169

Command Modes Command History Example CONFIGURATION Version 8.3.19.0 Version 8.3.12.0 Version 8.3.1.0 Introduced on S4820T Introduced on the S4810. Introduced FTOS(conf)#ipv6 pim register-filter REG-FIL_ACL FTOS(conf)#ipv6 access-list REG-FIL_ACL FTOS(conf-ipv6-acl)#deny ipv6 165:87:34::10/128 ff0e::225:1:2:0/112 FTOS(conf-ipv6-acl)#permit ipv6 any any FTOS(conf-ipv6-acl)#exit ipv6 pim rp-address e Configure a static PIM Rendezvous Point (RP) address for a group. This address is used by first-hop routers to send Register packets on behalf of the source multicast host. Syntax ipv6 pim rp-address address group-address group-address mask override To remove an RP address, use the no ipv6 pim re-address address group-address mask override. Parameters address group-address group-address mask override Enter the IPv6 RP address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zero. Enter the keyword group-address followed by the group address in the x:x:x:x::x format and then the mask in /nn format to assign that group address to the RP. The :: notation specifies successive hexadecimal fields of zero. Enter the keyword override to override the BSR updates with static RP. The override will take effect immediately during enable/disable. Note: This option is applicable to multicast group range. Defaults No default values or behavior Command Modes CONFIGURATION Command History Version 8.3.19.0 Version 8.3.12.0 Version 7.4.1.0 Introduced on S4820T Introduced on the S4810. Introduced Usage Information The RP addresses are stored in the order in which they are entered. RP addresses learnt via BSR take priority over static RP addresses. Without the override option, RPs advertised by the BSR updates take precedence over the statically configured RPs. PIM-Sparse Mode (PIM-SM) | 1169