Dell Force10 S4820T FTOS Command Reference Guide - Page 1450

www.dell.com | support.dell.com stack-unit renumber s Change the stack member ID of any stack member or a stand-alone S-Series. Syntax Parameters Defaults Command Modes Command History Usage Information Example Related Commands stack-unit 0-11 renumber 0-11 0-11 The first instance of this value is the stack member unit identifier of the switch that you want add to the stack. Range: 0-11. The second instance of this value is the desired new unit identifier number. none EXEC Privilege Version 8.3.19.0 Introduced on S4820T Version 7.7.1.0 Introduced on S-Series You can renumber any switch, including the management unit or a stand-alone unit. You cannot renumber a unit to a number of an active member in the stack. When executing this command on the master, the stack reloads. When the members are renumbered, only that specific unit will reset and come up with the new unit number. FTOS#stack-unit 5 renumber 6 Renumbering will reset the unit. Warning: Interface configuration for current unit will be lost! Proceed to renumber [confirm yes/no]: reload reset stack-unit show system (S-Series, S4810 and S4820T) Reboot FTOS. Reset the designated S-Series stack member. Display the current status of all stack members or a specific member. stack-unit stack-group Configure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure the unit is assigned to the correct group. Syntax stack-unit unit-id stack-group stack-group-id Use no stack-unit unit-id stack-group stack-id to remove the current stack group configuration. 1450 | S-Series Stacking Commands