Dell Force10 S4820T FTOS Command Reference Guide - Page 410
Command, History, Syntax, Parameters, Defaults, Command Modes, Usage, Information, Related
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 410 highlights
www.dell.com | support.dell.com Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series redistribute c et s Redistribute routes into BGP. Syntax redistribute [connected | static] [route-map map-name] To disable redistribution, use the no redistribution [connected | static] [route-map map-name] command. Parameters connected static route-map map-name Enter the keyword connected to redistribute routes from physically connected interfaces. Enter the keyword static to redistribute manually configured routes. These routes are treated as incomplete routes. (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ip address • set community • set local-preference • set metric • set next-hop • set origin • set weight If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Command Modes ROUTER BGP Address Family (conf-router_bgp_af) Usage Information If you do not configure default-metric command in addition to the redistribute command, or there is no route map to set the metric, the metric for redistributed static and connected is "0". To redistribute the default route (0.0.0.0/0) configure the neighbor default-originate command. Related Commands Command History neighbor default-originate Inject the default route. Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series 410 | Border Gateway Protocol IPv4 (BGPv4)