Dell Force10 S4820T FTOS Command Reference Guide - Page 326

www.dell.com | support.dell.com Syntax Parameters Defaults Command Modes Related Commands Command History capture bgp-pdu neighbor ipv4-address direction {both | rx | tx} To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-pdu neighbor ipv4-address command. ipv4-address direction {both | rx | tx} Not configured. EXEC Privilege Enter the IPv4 address of the target BGP neighbor. Enter the keyword direction and a direction- either rx for inbound, tx for outbound, or both. capture bgp-pdu max-buffer-size show capture bgp-pdu neighbor Specify a size for the capture buffer. Display BGP packet capture information Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.7.1.0 Version 7.5.1.0 Introduced on the S4820T. Introduced on the S4810. Introduced support on S-Series Introduced support on C-Series Introduced capture bgp-pdu max-buffer-size c e s Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6 addresses. Syntax Parameters Defaults Command Modes Related Commands Command History capture bgp-pdu max-buffer-size 100-102400000 100-102400000 Enter a size for the capture buffer. 40960000 bytes. EXEC Privilege capture bgp-pdu neighbor capture bgp-pdu neighbor (ipv6) show capture bgp-pdu neighbor Enable capture of an IPv4 BGP neighbor packet. Enable capture of an IPv6 BGP neighbor packet. Display BGP packet capture information for an IPv6 address on the E-Series. Version 8.3.19.0 Introduced on the S4820T. Version 8.3.7.0 Introduced on the S4810. 326 | Border Gateway Protocol IPv4 (BGPv4)