Dell Force10 S4820T FTOS Command Reference Guide - Page 1416
snmp-server enable traps
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1416 highlights
www.dell.com | support.dell.com Command History Version 8.3.19.0 Version 8.3.11.1 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 Introduced on S4820T Introduced on Z9000 Introduced on S4810 Support added for S-Series Support added for C-Series E-Series legacy command snmp-server enable traps c e s z Enable SNMP traps. Syntax snmp-server enable traps [notification-type] [notification-option] To disable traps, use the no snmp-server enable traps [notification-type] [notification-option] command. Parameters notification-type notification-option Enter the type of notification from the list below: • bgp-Notification of changes in BGP process • ecfm - Notification of changes to ECFM • envmon-For Dell Force10, device notifications when an environmental threshold is exceeded • isis - Notification of intermediate service traps. • lacp - Notification of changes to • snmp-Notification of RFC 1157 traps. • stp -Notification of state change in Spanning Tree protocol (RFC 1493) • vlt-Notification of virtual link trunking • vrrp-Notification of state change in a VRRP group • xstp-Notification of state change in MSTP (802.1s), RSTP (802.1w), and PVST+ For the envmon notification-type, enter one of the following optional parameters: • cam-utilization • fan • supply • temperature For the snmp notification-type, enter one of the following optional parameters: • authentication • coldstart • linkdown • linkup Defaults Not enabled. Command Modes CONFIGURATION 1416 | Simple Network Management Protocol and Syslog