Dell Force10 S4820T FTOS Command Reference Guide - Page 674

www.dell.com | support.dell.com Related Commands Command History ip udp-broadcast-address ip udp-helper udp-port show ip udp-helper Configure a UDP IP address for broadcast Enable the UDP broadcast feature on an interface. Display the configured UDP helper(s) on all interfaces. Version 8.3.19.0 Version 8.3.7.0 Pre-version 8.3.7.0 Introduced on S4820T Introduced on S4810 Introduced on E-Series ExaScale ip udp-broadcast-address e Configure an IP UDP address for broadcast. Syntax ip udp-broadcast-address address To delete the configuration, use the no ip udp-broadcast-address address command. Parameters address Enter an IP broadcast address in dotted decimal format (A.B.C.D). Defaults Not Configured Command Modes INTERFACE (config-if) Usage Information When a UDP broadcast packet is flooded out of an interface, and the outgoing interface is configured using this command, the outgoing packet's IP destination address is replaced with the configured broadcast address. Command History Version 8.3.19.0 Version 8.3.7.0 Pre-version 8.3.7.0 Introduced on S4820T Introduced on S4810 Introduced on E-Series ExaScale Related Commands debug ip udp-helper show ip udp-helper Enable debug and display the debug information on a console. Display the configured UDP helper(s) on all interfaces. ip udp-helper udp-port e Enable the UDP broadcast feature on an interface either for all UDP ports or a specified list of UDP ports. Syntax ip udp-helper udp-port [udp-port-list] To disable the UDP broadcast on a port, use the no ip udp-helper udp-port [udp-port-list] command. 674 | Interfaces