Dell Force10 S4820T FTOS Command Reference Guide - Page 1109

Parameters Defaults Command Modes Command History Example Usage Information process-id vrf name Enter a number for the OSPF instance. Range: 1 to 65535. (Optional) E-Series Only: Enter the VRF process identifier to tie the OSPF instance to the VRF. All network commands under this OSPF instance are subsequently tied to the VRF instance. Not configured. CONFIGURATION Version 8.3.19.0 Version 8.3.7.0 Version 7.9.1.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S4820T Introduced on S4810 Introduced VRF Introduced support of Multi-Process OSPF. Introduced on S-Series Introduced on C-Series Introduced on E-Series FTOS(conf)#router ospf 2 FTOS(conf-router_ospf)# You must have an IP address assigned to an interface to enter the ROUTER OSPF mode and configure OSPF. Once the OSPF process and the VRF are tied together, the OSPF Process ID cannot be used again in the system. show config c e s Display the non-default values in the current OSPF configuration. Syntax Command Modes show config ROUTER OSPF Command History Example Version 8.3.19.0 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S4820T Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series FTOS(conf-router_ospf)#show config ! router ospf 3 passive-interface FastEthernet 0/1 FTOS(conf-router_ospf)# Open Shortest Path First (OSPFv2) | 1109