Dell Force10 S4820T FTOS Command Reference Guide - Page 833
Allows you to assign one peer to a existing peer group., configuration takes precedence over
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 833 highlights
Parameters Defaults Command Modes Command History Usage Information ipv6-address peer-group-name Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. (OPTIONAL) Enter the name of the peer group. Disabled. ROUTER BGPV6-ADDRESS FAMILY Version 8.3.19.0 Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series ExaScale Introduced on E-Series TeraScale If the set ipv6 next-hop command in the ROUTE-MAP mode is configured, its configuration takes precedence over the neighbor next-hop-self command. neighbor peer-group (assigning peers) c e Allows you to assign one peer to a existing peer group. Syntax Parameters Defaults Command Modes Command History Usage Information neighbor ipv6-address peer-group peer-group-name To delete a peer from a peer group, use the no neighbor ipv6-address peer-group peer-group-name command. ipv6-address peer-group peer-group-name Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. Enter the keyword peer-group followed by the name of a configured peer group. (maximum 16 characters) Not configured. ROUTER BGP Version 8.3.19.0 Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series ExaScale Introduced on E-Series TeraScale You can assign up to 64 peers to one peer group. IPv6 Border Gateway Protocol (IPv6 BGP) | 833