Dell Force10 S4820T FTOS Command Reference Guide - Page 72
cam-audit linecard, cam-audit stack-unit
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
www.dell.com | support.dell.com Command History Usage Information Related Commands Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command A MOTD banner message is displayed only in EXEC Privilege mode after entering the enable command followed by the password. These banners are not displayed to users in EXEC (non-privilege) mode. banner exec banner login Sets a banner to be displayed when you enter the EXEC Privilege mode. Sets a banner to be displayed after successful login to the system. cam-audit linecard e Enable audit of the IPv4 forwarding table on all line cards. Syntax cam-audit linecard all ipv4-fib interval time-in-minutes Parameters all ipv4-fib interval time-in-minutes Enter the keyword all to enable CAM audit on all line cards. Enter the keyword ipv4-fib to designate the CAM audit on the IPv4 forwarding entries. Enter the keyword interval followed by the frequency in minutes of the CAM audit. Range: 5 to 1440 minutes (24 hours) Default: 60 minutes Defaults Disabled Command Modes CONFIGURATION Command History Usage Information Version 7.4.1.0 Introduced on E-Series Enables periodic audits of software and hardware copies of the IPv4 forwarding table. cam-audit stack-unit Enable audit of the IPv4 and IPv6 forwarding table on all line cards. Syntax cam-audit stack-unit [all | ipv4-fib | ipv6-fib] interval time-in-minutes 72 | Control and Monitoring