Dell Force10 S4820T FTOS Command Reference Guide - Page 730

www.dell.com | support.dell.com connected 17 0 static 3 0 ospf 100 1368 2 Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5 Total 1388 2 Total 1388 active route(s) using 222440 bytes Total 2 non-active route(s) using 128 bytes FTOS> Table 24-15. show ip route summary Column Headings Column Heading Description Route Source Active Routes Non-active Routes ospf 100 Total 1388 active... Identifies how the route is configured in FTOS. Identifies the best route if a route is learned from two protocol sources. Identifies the back-up routes when a route is learned by two different protocols. If the best route or active route goes down, the non-active route will become the best route. If routing protocols (OSPF, RIP) are configured and routes are advertised, then information on those routes is displayed. Displays the number of active and non-active routes and the memory usage of those routes. If there are no routes configured in the FTOS, this line does not appear. Related Commands show ip route Display information about the routes found in switch. show ip traffic c e s View IP, ICMP, UDP, TCP and ARP traffic statistics. Syntax Parameters Command Modes show ip traffic [all | cp | rp1 | rp2] Note: These options are supported only on the E-Series. all (OPTIONAL) Enter the keyword all to view statistics from all processors. If you do not enter a keyword, you also view all statistics from all processors. cp (OPTIONAL) Enter the cp to view only statistics from the Control Processor. rp1 (OPTIONAL) Enter the keyword rp1 to view only the statistics from Route Processor 1. rp2 (OPTIONAL) Enter the keyword rp2 to view only the statistics from Route Processor 2. EXEC Privilege 730 | IPv4 Routing