Dell Force10 S4820T FTOS Command Reference Guide - Page 877

Command History Usage Information Version 8.3.19.0 Version 8.4.2.1 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series TeraScale If the set ipv6 next-hop command in the ROUTE-MAP mode is configured, its configuration takes precedence over the neighbor next-hop-self command. neighbor remove-private-as c e Remove private AS numbers from the AS-PATH of outgoing updates. Syntax Parameters Defaults Command Modes Command History neighbor ipv6-address | peer-group-name remove-private-as To return to the default, use the no neighbor ipv6-address | peer-group-name remove-private-as command. ipv6-address peer-group-name (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. (OPTIONAL) Enter the name of the peer group to remove the private AS numbers Disabled (that is, private AS number are not removed). ROUTER BGPV6-ADDRESS FAMILY Version 8.3.19.0 Version 8.4.2.1 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series TeraScale neighbor route-map c e Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group. Syntax Parameters neighbor ipv6-address | peer-group-name route-map map-name [in | out] To remove the route map, use the no neighbor [ipv6-address | peer-group-name] route-map map-name [in | out] command. ipv6-address peer-group-name (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. (OPTIONAL) Enter the name of the peer group. IPv6 Border Gateway Protocol (IPv6 BGP) | 877