Dell Force10 S4820T FTOS Command Reference Guide - Page 1281

Usage Information offset-list c e s You can enable an unlimited number of RIP networks. RIP operates over interfaces configured with any address specified by the network command. Specify a number to add to the incoming or outgoing route metrics learned via RIP. Syntax Parameters Defaults Command Modes Command History offset-list prefix-list-name {in | out} offset [interface] To delete an offset list, use the no offset-list prefix-list-name {in | out} offset [interface] command. prefix-list-name offset interface Enter the name of an established Prefix list to determine which incoming routes will be modified. Enter a number from zero (0) to 16 to be applied to the incoming route metric matching the access list specified. If you set an offset value to zero (0), no action is taken. (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Not configured. ROUTER RIP Version 8.3.19.0 Version 8.5.1.0 Version 8.3.7.0 Version 7.8.1.0 Introduced on S4820T Added support for 4-port 40G line cards on ExaScale. Introduced on S4810 Introduced on S-Series Routing Information Protocol (RIP) | 1281