Dell Force10 S4820T FTOS Command Reference Guide - Page 478

www.dell.com | support.dell.com Command History Version 8.3.19.0 Version 8.3.12.0 Version 8.3.16.0 Introduced on the S4820T Introduced on the S4810. Introduced on MXL 10/40GbE Switch IO Module Usage Information If you disable ETS in an output policy applied to an interface using the no ets mode on command, any previously configured QoS settings at the interface or global level take effect. If QoS settings are configured at the interface or global level and in an output policy map (service-policy output command), the QoS configuration in the output policy takes precedence. Related Commands dcb-output dcb-policy output Create a DCB output policy. Apply the output policy. fcoe priority-bits Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs. Syntax fcoe priority-bits priority-bitmap To remove the configured FCoE priority, use the no fcoe priority-bits command. Parameters priority-bitmap Enter the priority-bitmap range. Range: 1 to FF. Defaults 0x8 Command Modes PROTOCOL LLDP Command History Version 8.3.19.0 Version 8.3.12.0 Version 8.3.16.0 Introduced on the S4820T. Introduced on the S4810. Introduced on MXL 10/40GbE Switch IO Module Usage This command is available at the global level only. Information iscsi priority-bits Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs. Syntax iscsi priority-bits priority-bitmap To remove the configured iSCSI priority, use the no iscsi priority-bits command. 478 | Data Center Bridging