Dell Force10 S4820T FTOS Command Reference Guide - Page 586

www.dell.com | support.dell.com Version 7.6.1.0 Introduced on S-Series in Interface VLAN mode only to enable that system to act as an IGMP Proxy Querier. Version 7.5.1.0 Introduced on C-Series in Interface VLAN mode only to enable that system to act as an IGMP Proxy Querier. E-Series legacy command ip igmp ssm-map c e s Use a statically configured list to translate (*,G) memberships to (S,G) memberships. Syntax ip igmp ssm-map std-access-list source-address Undo this configuration, that is, remove SSM map (S,G) states and replace them with (*,G) states using the command ip igmp ssm-map std-access-list source-address command. Parameters Command Modes Command History Usage Information Related Commands std-access-list source-address Specify the standard IP access list that contains the mapping rules for multicast groups. Specify the multicast source address to which the groups are mapped. CONFIGURATION Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on S4820T Introduced on S4810 Introduced on C-Series and S-Series Introduced on E-Series Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in the IGMP groups. You may not use extended access lists with this command. When a static SSM map is configured and the router cannot find any matching access lists, the router continues to accept (*,G) groups. ip access-list standard Create a standard access list to filter based on IP address. ip igmp static-group c e s Configure an IGMP static group. 586 | Internet Group Management Protocol (IGMP)