Dell Force10 S4820T FTOS Command Reference Guide - Page 607

Command History Version 8.1.1.0 Version 7.5.1.0 Version 6.4.1.0 Introduced on E-Series ExaScale Introduced on C-Series Documentation modified-added Management to distinguish from duplex (10/ 100 Interfaces) Usage This command applies only to the Management interface on the RPMs. Information Related Commands interface ManagementEthernet duplex (Management) management route speed (Management interface) Configure the Management port on the system (either the Primary or Standby RPM). Set the mode of the Management interface. Configure a static route that points to the Management interface or a forwarding router. Set the speed on the Management interface. duplex (10/100 Interfaces) c e s Configure duplex mode on any physical interfaces where the speed is set to 10/100.Syntax duplex {half | full} To return to the default setting, enter no duplex. Parameters half Enter the keyword half to set the physical interface to transmit only in one direction. full Enter the keyword full to set the physical interface to transmit in both directions. Defaults Not configured Command Modes INTERFACE Command History Version 8.3.19.0 Version 8.3.7.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.4.1.0 Introduced on S4820T Introduced on S4810 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced Usage Information This command applies to any physical interface with speed set to 10/100. Note: Starting with FTOS 7.8.1.0, when a copper SFP2 module with catalog number GP-SFP2-1T is used in the S25P model of the S-Series, its speed can be manually set with the speed command. When the speed is set to 10 or 100 Mbps, the duplex command can also be executed. Interfaces | 607