Dell Force10 S4820T FTOS Command Reference Guide - Page 24

www.dell.com | support.dell.com 24 | CLI Basics To enter INTERFACE mode: 1. Verify that you are logged into the CONFIGURATION mode. 2. Enter the interface command followed by an interface type and interface number that is available on the switch. 3. The prompt changes to include the designated interface and slot/port number, as outlined in Table 2-3. Table 2-3. Interface prompts Prompt FTOS(conf-if)# FTOS(conf-if-gi-0/0)# FTOS(conf-if-te-0/0)# FTOS(conf-if-fo-0/0)# FTOS(conf-if-lo-0)# FTOS(conf-if-nu-0)# FTOS(conf-if-po-0)# FTOS(conf-if-vl-0)# FTOS(conf-if-so-0/0)# FTOS(conf-if-ma-0/0)# FTOS(conf-if-range)# Interface Type INTERFACE mode Gigabit Ethernet interface followed by slot/port information Ten Gigabit Ethernet interface followed by slot/port information Forty Gigabit Ethernet interface followed by slot/port information Loopback interface number. Null Interface followed by zero Port-channel interface number VLAN Interface followed by VLAN number (range 1 to 4094) SONET interface followed by slot/port information. Management Ethernet interface followed by slot/port information Designated interface range (used for bulk configuration; refer to interface range). LINE Mode Use the LINE mode to configure console or virtual terminal parameters. To enter LINE mode: 1. Verify that you are logged in to the CONFIGURATION mode. 2. Enter the line command. You must include the keywords console or vty and their line num- ber available on the switch.The prompt changes to include (config-line-console) or (config-line-vty). You can exit this mode by using the exit command. TRACE-LIST Mode When in the CONFIGURATION mode, use the trace-list command to enter the TRACE-LIST mode and configure a Trace list. 1. Verify that you are logged in to the CONFIGURATION mode. 2. Enter the ip trace-list command. You must include the name of the Trace list. The prompt change to include (conf-trace-acl).