Dell Force10 S4820T FTOS Command Reference Guide - Page 1459

storm-control multicast (Configuration) c s Configure the packets per second (pps) of multicast traffic allowed in to the C-Series and S-Series networks only. Syntax Parameters Defaults Command Modes Command History Usage Information storm-control multicast packets_per_second in To disable storm-control for multicast traffic into the network, use the no storm-control multicast packets_per_second in command. packets_per_second in C-Series and S-Series Only: Enter the packets per second of multicast traffic allowed into the network followed by the keyword in. Range: 0 to 33554431 No default behavior or values CONFIGURATION (conf) Version 8.3.19.0 Version 8.3.7.0 Version 7.6.1.0 Introduced on S4820T Introduced on S4810 Introduced on C-Series and S-Series only Broadcast traffic (all 0xFs) should be counted against broadcast storm control meter, not against the multicast storm control meter. It is possible, however, that some multicast control traffic may get dropped when storm control thresholds are exceeded. storm-control multicast (Interface) c s Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress only) network only. Syntax Parameters Defaults Command Modes storm-control multicast packets_per_second in To disable multicast storm control on the interface, use the no storm-control multicast packets_per_second in command. packets_per_second in C-Series and S-Series Only: Enter the packets per second of broadcast traffic allowed into the network. Range: 0 to 33554431 No default behavior or values INTERFACE (conf-if-interface-slot/port) Storm Control | 1459