Dell Force10 S4820T FTOS Command Reference Guide - Page 1382

www.dell.com | support.dell.com Related Commands ip trace-list permit permit udp Create a trace list. Assign a trace list filter to forward IP packets. Assign a trace list filter to forward UDP packets. permit udp e Configure a filter to pass UDP packets meeting the filter criteria. Syntax permit udp {source mask | any | host ip-address} [operator port [port]] {destination mask | any | host ip-address} [operator port [port]] [count [byte]] | log] [order number] To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no permit udp {source mask | any | host ip-address} {destination mask | any | host ip-address} command. Parameters source mask any host ip-address operator port port destination count byte log order number Enter the IP address of the network or host from which the packets were sent. (OPTIONAL) Enter a network mask in /prefix format (/x). Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host followed by the IP address to specify a host IP address. (OPTIONAL) Enter one of the following logical operand: • eq = equal to • neq = not equal to • gt = greater than • lt = less than • range = inclusive range of ports (you must specify two ports for the port parameter.) (OPTIONAL) Enter the application layer port number. Enter two port numbers if using the range logical operand. Range: 0 to 65535 Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count only bytes processed by the filter. (OPTIONAL) Enter the keyword log to have the information kept in a Trace-list log file. (OPTIONAL) Enter the keyword order followed by a number from 0 to 7 as the order number. Defaults Not configured. 1382 | Security