Dell Force10 S4820T FTOS Command Reference Guide - Page 1009

Syntax Defaults Command Modes Command History protocol lldp To disable LLDP globally on the chassis, use the no protocol lldp command. Disabled CONFIGURATION (conf-lldp) Version 8.3.19.0. Version 8.3.7.0 Version 7.7.1.0 Version 7.6.1.0 Version 7.4.1.0 Introduced on S4820T Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series protocol lldp (Interface) c e s Enter the LLDP protocol in the INTERFACE mode. Syntax [no] protocol lldp To return to the global LLDP configuration mode, use the no protocol lldp command from the Interface mode. Defaults LLDP is not enabled on the interface. Command Modes INTERFACE (conf-if-interface-lldp) Command History Version 7.7.1.0 Version 7.6.1.0 Version 7.4.1.0 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Information LLDP must be enabled globally from CONFIGURATION mode, before it can be configured on an interface. This command places you in LLDP mode on the interface; it does not enable the protocol. When you enter the LLDP protocol in the Interface context, it overrides global configurations. When you execute the no protocol lldp from the INTERFACE mode, interfaces will begin to inherit the configuration from the global LLDP CONFIGURATION mode. show lldp neighbors c e s Display LLDP neighbor information for all interfaces or a specified interface. Link Layer Discovery Protocol (LLDP) | 1009