Dell Force10 S4820T FTOS Command Reference Guide - Page 1417

Command History Usage Information Related Commands Version 8.3.19.0 Introduced on S4820T Version 8.3.11.1 Introduced on Z9000 Version 8.3.7.0 Introduced on S4810 Version 8.4.1.0 Support was added for VRRP traps. Version 7.6.1.0 Support added for S-Series; Added support for STP and xSTP traps. Version 7.5.1.0 Support added for C-Series E-Series legacy command FTOS supports up to 16 SNMP trap receivers. For the cam-utilization notification option, the system will generate syslogs and SNMP traps when the L3 host table or route table utilization goes above the threshold. This applies to the S4810 and S4820T only. If this command is not configured, no traps controlled by this command are sent. If you do not specify a notification-type and notification-option, all traps are enabled. snmp-server community Enable SNMP and set the community string. snmp-server engineID c e s z Configure name for both the local and remote SNMP engines on the router. Syntax snmp-server engineID [local engineID] [remote ip-address udp-port port-number engineID] To return to the default, use the no snmp-server engineID [local engineID] [remote ip-address udp-port port-number engineID] command Parameters local engineID remote ip-address udp-port port-number engineID Enter the keyword local followed by the engine ID number that identifies the copy of the SNMP on the local device. Format (as specified in RFC 3411): 12 octets. • The first 4 octets are set to the private enterprise number. • The remaining 8 octets are the MAC address of the chassis. Enter the keyword remote followed by the IP address that identifies the copy of the SNMP on the remote device. Enter the keyword udp-port followed by the UDP (User Datagram Protocol) port number on the remote device. Range: 0 to 65535 Default: 162 Defaults As above Command Modes CONFIGURATION Simple Network Management Protocol and Syslog | 1417