Dell Force10 S4820T FTOS Command Reference Guide - Page 484

www.dell.com | support.dell.com • All 802.1p priorities are grouped in priority group 0. • 100% of the port bandwidth is assigned to priority group 0. The complete bandwidth is equally assigned to each priority class so that each class has 12-13%. Related Commands priority-group priority-group qos-policy set-pgid Create an ETS priority group. Associate an ETS priority group with an ETS output policy. Configure the priority-group. qos-policy-output ets Create a QoS output policy to configure the ETS bandwidth allocation and scheduling for priority traffic. Syntax qos-policy-output policy-name ets To remove the QoS output policy, use the no qos-policy-output ets command. Parameters policy-name Enter the policy name. Maximum: 32 characters. Command Modes CONFIGURATION Command History Version 8.3.19.0 Version 8.3.12.0 Version 8.3.16.0 Introduced on the S4820T. Introduced on the S4810. Introduced on MXL 10/40GbE Switch IO Module Usage Information If an error occurs in an ETS output-policy configuration, the configuration is ignored and the scheduler and bandwidth allocation settings are reset to the ETS default values (all priorities are in the same ETS priority group and bandwidth is allocated equally to each priority). If an error occurs when a port receives a peer's ETS configuration, the port's configuration is reset to the previously configured ETS output policy. If no ETS output policy was previously applied, the port is reset to the default ETS parameters. Related Commands scheduler bandwidth-percentage Schedule priority traffic in port queues. Bandwidth percentage allocated to priority traffic in port queues. scheduler Configure the method used to schedule priority traffic in port queues. Syntax scheduler value 484 | Data Center Bridging