Dell Force10 S4820T FTOS Command Reference Guide - Page 656

www.dell.com | support.dell.com When you configure a speed for the 10/100/1000 interface, you should confirm the negotiation auto command setting. Both sides of the link should have auto-negotiation either enabled or disabled. For speed settings of 1000 or auto, the software sets the link to auto-negotiation and you cannot change that setting. In FTOS, the command speed 100 is an exact equivalent of speed auto 100 in IOS. Note: Starting with FTOS 7.8.1.0, when a copper SFP2 module with catalog number GP-SFP2-1T is used in the S25P model of the S-Series, its speed can be manually set with the speed command. When the speed is set to 10 or 100 Mbps, the duplex command can also be executed. Related Commands duplex (10/100 Interfaces) negotiation auto Configure duplex mode on physical interfaces with the speed set to 10/100. Enable or disable auto-negotiation on an interface. speed (Management interface) c e Set the speed for the Management interface. z Syntax speed {10 | 100 | auto} To return to the default setting, use the no speed {10 | 100} command. Parameters 10 100 auto Enter the keyword 10 to set the interface's speed to 10 Mb/s. Enter the keyword 100 to set the interface's speed to 100 Mb/s. Enter the keyword auto to set the interface to auto-negotiate its speed. Defaults auto Command Modes INTERFACE Command History Version 8.3.19.0 Version 8.3.11.1 Version 8.3.11.1 Version 8.1.1.0 Version 7.5.1.0 pre-Version 6.2.1.0 Introduced on S4820T. Introduced on Z9000. Introduced on S55, S60, and S4810. Introduced on E-Series ExaScale. Introduced on C-Series. Introduced for E-Series. Usage This command is found on the Management interface only. Information 656 | Interfaces