Dell Force10 S4820T FTOS Command Reference Guide - Page 550

www.dell.com | support.dell.com Example (show frrp ring-id) Example (show frrp ring-id summary) Related Commands FTOS#show frrp 1 Ring protocol 1 is in Master mode Ring Protocol Interface: Primary : GigabitEthernet 0/16 State: Forwarding Secondary: Port-channel 100 State: Blocking Control Vlan: 1 Ring protocol Timers: Hello-Interval 50 msec Dead-Interval 150 msec Ring Master's MAC Address is 00:01:e8:13:a3:19 Topology Change Statistics: Tx:110 Rx:45 Hello Statistics: Tx:13028 Rx:12348 Number of state Changes: 34 Member Vlans: 1000-1009 FTOS# FTOS#show frrp 2 summary Ring-ID State Mode Ctrl_Vlan Member_Vlans 2 Up Master 2 11-20, 25, 27-30 FTOS# protocol frrp Enter the Resilient Ring Protocol and designate a ring identification timer c e Syntax Parameters Defaults Command Modes Command History Set the hello or dead interval for the Ring control packets. timer {hello-interval milliseconds}| {dead-interval milliseconds} To remove the timer, use the no timer {hello-interval [milliseconds]}| {dead-interval milliseconds} command. hello-interval milliseconds dead-interval milliseconds Enter the keyword hello-interval followed by the time, in milliseconds, to set the hello interval of the control packets. The milliseconds must be enter in increments of 50 milliseconds, for example 50, 100, 150 and so on. If an invalid value is entered, an error message is generated. Range: 50 to 2000ms Default: 500 ms Enter the keyword dead-interval followed by the time, in milliseconds, to set the dead interval of the control packets. Range: 50 to 6000ms Default: 1500ms Note: The configured dead interval should be at least three times the hello interval Default as shown CONFIGURATION (conf-frrp) Version 8.2.1.0 Version 7.4.1.0 Introduced for the C-Series Introduced 550 | Force10 Resilient Ring Protocol (FRRP)