Dell Force10 S4820T FTOS Command Reference Guide - Page 265

Command History Related Commands Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on E-Series ExaScale Support added for S-Series Support added for C-Series Introduced for E-Series match interface match ip address match ip next-hop match ip route-source match route-type match tag Redistribute routes that match the next-hop interface. Redistribute routes that match an IP address. Redistribute routes that match the next-hop IP address. Redistribute routes that match routes advertised by other routers. Redistribute routes that match a route type. Redistribute routes that match a specific tag. match origin c e s Configure a filter to match routes based on the value found in the BGP path ORIGIN attribute. Syntax match origin {egp | igp | incomplete} Parameters egp igp incomplete Enter the keyword egp to match routes originating outside the AS. Enter the keyword igp to match routes originating within the same AS. Enter the keyword incomplete to match routes with incomplete routing information. Defaults Not configured. Command Modes ROUTE-MAP Command History Version 8.1.1.0 Introduced on E-Series ExaScale pre-Version 6.1.1.0 Introduced for E-Series match route-type c e s Configure a filter to match routes based on the how the route is defined. Syntax Parameters match route-type {external [type-1 | type-2] | internal | level-1 | level-2 | local} external [type-1| type-2] internal Enter the keyword external followed by either type-1 or type-2 to match only on OSPF Type 1 routes or OSPF Type 2 routes. Enter the keyword internal to match only on routes generated within OSPF areas. Access Control Lists (ACL) | 265