Dell Force10 S4820T FTOS Command Reference Guide - Page 476

www.dell.com | support.dell.com To remove the DCBX version, use the dcbx version {auto | cee | cin | ieee-v2.5} command. Parameters auto | cee | cin | ieee-v2.5 Enter the DCBX version type used on the interface, where: • auto: configures the port to operate using the DCBX version received from a peer. • cee: configures the port to use CDD (Intel 1.01). • cin: configures the port to use Cisco-Intel-Nuova (DCBX 1.0). • ieee-v2: configures the port to use IEEE 802.1az (Draft 2.5). Defaults Auto Command Modes PROTOCOL LLDP INTERFACE PROTOCOL LLDP Command History Version 8.3.19.0 Version 8.3.12.0 Version 8.3.16.0 Introduced on the S4820T. Introduced on the S4810. Introduced on MXL 10/40GbE Switch IO Module Usage Information DCBX requires that you enable LLDP to advertise DCBX TLVs to peers. Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the DCBX configuration on a port, use the show interface dcbx detail command. debug dcbx Enable DCBX debugging. Syntax debug dcbx {all | auto-detect-timer | config-exchng | fail | mgmt | resource | sem | tlv} To disable DCBX debugging, use the no debug dcbx command. Parameters {all | auto-detect-timer | config-exchng | fail | mgmt | resource | sem | tlv} Enter the type of debugging, where: • all: enables all DCBX debugging operations. • auto-detect-timer: enables traces for DCBX auto-detect timers. • config-exchng: enables traces for DCBX configuration exchanges. • fail: enables traces for DCBX failures. • mgmt: enables traces for DCBX management frames. • resource: enables traces for DCBX system resource frames. • sem: enables traces for the DCBX state machine. • tlv: enables traces for DCBX TLVs. Defaults none Command Modes EXEC PRIVILEGE 476 | Data Center Bridging