Dell Force10 S4820T FTOS Command Reference Guide - Page 1401

Usage Information Version 8.1.1.0 Version 7.7.1.0 Version 7.6.1.0 Version 6.2.1.1 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced on E-Series When sFlow is enable on an interface, flow sampling is done on any traffic going out of the interface. Note: Once a physical port is a member of a LAG, it will inherit the sFlow configuration from the LAG port. Related Commands sflow enable (Global) Turn sFlow on globally sflow extended-gateway enable e Enable packing information on an extended gateway. Syntax sflow extended-gateway [extended-router] [extended-switch] enable To disable packing information, use the no sflow extended-gateway [extended-router] [extended-switch] enable command. Parameters extended-router extended-switch enable Enter the keyword extended-router to collect extended router information. Enter the keyword extended-switch to collect extended switch information. Enter the keyword enable to enable global extended information. Defaults Disabled Command Modes CONFIGURATION Command History Version 8.1.1.0 Version 7.4.1.0 Introduced on E-Series ExaScale Introduced on E-Series Usage Information The show sflow command displays the configured global extended information. FTOS 7.8.1.0 and later enhances the sFlow implementation for real time traffic analysis on the E-Series to provide extended gateway information in cases where the destination IP addresses are learned by different routing protocols, and for cases where the destination is reachable over ECMP. sFlow | 1401