Dell Force10 S4820T FTOS Command Reference Guide - Page 79

Usage Information Version 7.6.1.0 Version 7.5.1.0 Introduced on S-Series Introduced on C-Series and E-Series The chassis MIB contain the entry chSysXfpRecvPower in the chSysPortTable table. Periodically, IFA polls the XFP power for each of the ports, and sends the values to IFM where it is cached. The default interval for the polling is 300 seconds (5 minutes). Use this command to enable the polling and to configure the polling frequency. end c e s Syntax Command Modes Command History Related Commands Return to the EXEC Privilege mode from other command modes (for example, the CONFIGURATION or ROUTER OSPF modes). end CONFIGURATION, SPANNING TREE, MULTIPLE SPANNING TREE, LINE, INTERFACE, TRACE-LIST, VRRP, ACCESS-LIST, PREFIX-LIST, AS-PATH ACL, COMMUNITY-LIST, ROUTER OSPF, ROUTER RIP, ROUTER ISIS, ROUTER BGP Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command exit Return to the lower command mode. epoch e Syntax Parameters Defaults Command Modes Set the epoch scheduling time for the chassis. epoch {2.4 |3.2 | 10.4} 2.4 Enter the keyword 2.4 to set the epoch to 2.4 micro-seconds and lower the latency. This option is available on the E600i and E1200i E-Series ExaScale systems only. 3.2 Enter the keyword 3.2 to set the epoch to 3.2 micro-seconds and lower the latency. This option is available on the E600/E600i and E1200/E1200i only. ExaScale does not supports this setting with FTOS 8.3.1.0 and later. 10.4 Enter the keyword 10.4 to set the epoch to 10.4 micro-seconds. This is the default setting and is available on the E300, E600/E600i, and E1200. 10.4 CONFIGURATION Control and Monitoring | 79