Dell Force10 S4820T FTOS Command Reference Guide - Page 1278

www.dell.com | support.dell.com c e s Set the interface to send a specific version of RIP. The version you set on the interface overrides the version command in the ROUTER RIP mode. Syntax Parameters Defaults Command Modes Command History Usage Information Related Commands ip rip send version [1] [2] To return to the default value, enter no ip rip send version. 1 (OPTIONAL) Enter the number 1 for RIP version 1. The default is RIPv1. 2 (OPTIONAL) Enter the number 2 for RIP version 2. RIPv1 INTERFACE Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S4820T Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series To enable the interface to send both version of RIP packets, enter ip rip send version 1 2. ip rip receive version version Sets the RIP version for the interface to receive traffic. Sets the RIP version to be used for the switch software. ip split-horizon c e s Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme prevents any routes learned over a specific interface to be sent back out that interface. Syntax Defaults Command Modes Command History ip split-horizon To disable split-horizon, enter no ip split-horizon. Enabled INTERFACE Version 8.3.19.0 Version 8.3.7.0 Introduced on S4820T Introduced on S4810 1278 | Routing Information Protocol (RIP)