Dell Force10 S4820T FTOS Command Reference Guide - Page 1145

Defaults Command Modes Command History Usage Information as above CONFIGURATION Version 8.3.19.0 Version 8.3.12.0 Version 8.2.1.0 Version 7.6.1.0 Introduced on S4820T Introduced on the S4810. Introduced on E-Series ExaScale. Added the ipv6 option for E-Series. Introduced on E-Series When an NSF-capable router comes up, it announces the graceful restart capability and restart duration as a Hello option. The receiving router notes the Hello option. Routers not NSF capable will discard the unknown Hello option and adjacency is not affected. When an NSF-capable router goes down, neighboring PIM speaker preserves the states and continues the forwarding of multicast traffic while the neighbor router restarts. ip pim join-filter c e s Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command prevents the PIM SM router from creating state based on multicast source and/or group. Syntax Parameters Defaults Command Modes Command History Example ip pim join-filter ext-access-list {in | out} Remove the access list using the command no ip pim join-filter ext-access-list {in | out} ext-access-list in out Enter the name of an extended access list. Enter this keyword to apply the access list to inbound traffic. Enter this keyword to apply the access list to outbound traffic. None INTERFACE Version 8.3.19.0 Version 8.3.7.0 Version 8.1.1.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on S4820T Introduced on S4810 Introduced on E-Series ExaScale Introduced on C-Series on port-channels and S-Series Introduced on E-Series. FTOS(conf)# ip access-list extended iptv-channels FTOS(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24 FTOS(config-ext-nacl)# permit ip any 232.1.1.0/24 FTOS(config-ext-nacl)# permit ip 100.1.1.0/16 any PIM-Sparse Mode (PIM-SM) | 1145