Dell Force10 S4820T FTOS Command Reference Guide - Page 1561

Related Commands buffer-profile (Configuration) Create a buffer profile that can be applied to an interface. Hardware Commands These commands display information from a hardware sub-component or ASIC. The commands are: • clear hardware stack-unit • clear hardware system-flow • hardware watchdog • show hardware layer2 acl • show hardware layer3 • show hardware stack-unit • show hardware system-flow clear hardware stack-unit s Clear statistics from selected hardware components. Syntax clear hardware stack-unit 0-7 {counters | unit 0-1 counters | cpu data-plane statistics | cpu party-bus statistics | stack-port 0-52} Parameters stack-unit 0-7 counters unit 0-1 counters cpu data-plane statistics cpu party-bus statistics stack-port 0-52 Enter the keyword stack-unit followed by 0 to 7 to select a particular stack member and then enter one of the following command options to clear a specific collection of data. Enter the keyword counters to clear the counters on the selected stack member. Enter the keyword unit along with a port-pipe number, from 0 to 1, followed by the keyword counters to clear the counters on the selected port-pipe. Note: S25 models (S25N, S25P, S25V, etc.) have only port-pipe 0. Enter the keywords cpu data-plane statistics to clear the data plane statistics. Enter the keywords cpu party-bus statistics to clear the management statistics. Enter the keyword stack-port followed by the port number of the stacking port to clear the statistics of the particular stacking port. Range: 0 to 52 Note: You can identify stack port numbers by physical inspection of the rear modules. The numbering is the same as for the 10G ports. You can also inspect the output of the show system stack-ports command. S-Series Debugging and Diagnostics | 1561