Dell Force10 S4820T FTOS Command Reference Guide - Page 1377

Parameters Defaults Command Modes Related Commands source mask any host ip-address operator port port destination count byte log order number Enter the IP address of the network or host from which the packets were sent. (OPTIONAL) Enter a network mask in /prefix format (/x). Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host followed by the IP address to specify a host IP address. (OPTIONAL) Enter one of the following logical operand: • eq = equal to • neq = not equal to • gt = greater than • lt = less than • range = inclusive range of ports (you must specify two ports for the port command parameter.) Enter the application layer port number. Enter two port numbers if using the range logical operand. Range: 0 to 65535. The following list includes some common TCP port numbers: • 23 = Telnet • 20 and 21 = FTP • 25 = SMTP • 169 = SNMP Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count only bytes processed by the filter. (OPTIONAL) Enter the keyword log to have the information kept in a Trace-list log file. (OPTIONAL) Enter the keyword order followed by a number from 0 to 7 as the order number. Not configured. TRACE LIST deny deny udp Assign a trace list filter to deny IP traffic. Assign a trace list filter to deny UDP traffic. Security | 1377