Dell Force10 S4820T FTOS Command Reference Guide - Page 1422

www.dell.com | support.dell.com Usage Information In order to configure the router to send SNMP notifications, you must enter at least one snmp-server host command. If you enter the command with no keywords, all trap types are enabled for the host. If you do not enter an snmp-server host command, no notifications are sent. In order to enable multiple hosts, you must issue a separate snmp-server host command for each host. You can specify multiple notification types in the command for each host. Several host commands for the same ip can coexist. For the same host ip, community-name, and udp-port commands, the trap over-writes informs and vice-versa. The snmp-server host command is used in conjunction with the snmp-server enable command. Use the snmp-server enable command to specify which SNMP notifications are sent globally. For a host to receive most notifications, at least one snmp-server enable command and the snmp-server host command for that host must be enabled. Note: For v1 / v2c trap configuration, if the community-string is not defined using the snmp-server community command prior to using this command, the default form of the snmp-server community command will automatically be configured, with the community-name the same as specified in the snmp-server host command. Configuring Informs To send an inform, follow the step below. Related Commands 1. Configure a remote engine ID. 2. Configure a remote user. 3. Configure a group for this user with access rights. 4. Enable traps. 5. Configure a host to receive informs. snmp-server enable traps snmp-server community Enable SNMP traps. Configure a new community SNMPv1 or SNMPv2c snmp-server location c e s z Configure the location of the SNMP server. Syntax snmp-server location text To delete the SNMP location, enter no snmp-server location. Parameters text Enter an alpha-numeric text string, up to 55 characters long. 1422 | Simple Network Management Protocol and Syslog