Dell Force10 S4820T FTOS Command Reference Guide - Page 581
debug ip igmp
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 581 highlights
Usage Information IGMP commands accept only non-VLAN interfaces - specifying VLAN will not yield a result. debug ip igmp c e s Enable debugging of IGMP packets. Syntax Parameters Defaults Command Modes Command History Usage Information debug ip igmp [group address | interface] To disable IGMP debugging, enter no debug ip igmp [group address | interface]. To disable all debugging, enter undebug all. group-address interface (OPTIONAL) Enter the IP multicast group address in dotted decimal format. (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by: -C-Series and S-Series range: 1-128 -E-Series range: 1-32 for EtherScale, 1-255 for TeraScale • For SONET interfaces, enter the keyword sonet followed by the slot/port information. This keyword is only available on E-Series and C-Series. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Disabled EXEC Privilege Version 8.3.19.0 Introduced on S4820T Version 8.3.7.0 Introduced on S4810 Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series legacy command IGMP commands accept only non-VLAN interfaces - specifying a VLAN will not yield a result. This command displays packets for IGMP and IGMP Snooping. Internet Group Management Protocol (IGMP) | 581