Dell Force10 S4820T FTOS Command Reference Guide - Page 1096

www.dell.com | support.dell.com Parameters Defaults Command Modes Command History Usage Information Related Commands To return to default value, enter no ip ospf cost. cost Enter a number as the cost. Range: 1 to 65535. The default cost is based on the reference bandwidth. INTERFACE Version 8.3.19.0 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S4820T Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series If this command is not configured, cost is based on the auto-cost command. When you configure OSPF over multiple vendors, use the ip ospf cost command to ensure that all routers use the same cost. Otherwise, OSPF routes improperly. auto-cost Control how the OSPF interface cost is calculated. ip ospf dead-interval c e s Set the time interval since the last hello-packet was received from a router. After the interval elapses, the neighboring routers declare the router dead. Syntax ip ospf dead-interval seconds To return to the default values, enter no ip ospf dead-interval. Parameters seconds Enter the number of seconds for the interval. Range: 1 to 65535. Default: 40 seconds. Defaults 40 seconds Command Modes INTERFACE Command History Version 8.3.19.0 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S4820T Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series 1096 | Open Shortest Path First (OSPFv2)