Dell Force10 S4820T FTOS Command Reference Guide - Page 963

Parameters Defaults Command Modes Command History Related Commands mac-address output interface vlan vlan-id Enter the 48-bit hexidecimal address in nn:nn:nn:nn:nn:nn format. Enter the keyword output followed by one of the following interfaces: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1 to 128 E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Enter the keyword vlan followed by a VLAN ID. Range:1 to 4094. Not configured. CONFIGURATION Version 8.3.19.0 Version 8.5.1.0 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S4820T. Added support for 4-port 40G line cards on ExaScale. Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series show mac-address-table Displays the MAC address table. mac-address-table station-move threshold c e Change the frequency with which the MAC address station-move trap is sent after a MAC address changes in a VLAN. A trap is sent if a station move is detected above a threshold number of times in a given interval. Syntax Parameters [no] mac-address-table station-move threshold number interval count threshold number interval seconds Enter the keyword threshold followed by the number of times MAC addresses in VLANs can change before an SNMP trap is sent. Range: 1 to 10 Enter the keyword interval followed by the number of seconds. Range: 5 to 60 Layer 2 | 963