Dell Force10 S4820T FTOS Command Reference Guide - Page 255

Command History Usage Information Related Commands Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on E-Series ExaScale Support added for S-Series Support added for C-Series Introduced for E-Series Sequence numbers for this filter are automatically assigned starting at sequence number 5. If the options ge or le are not used, only packets with an exact match to the prefix are filtered. deny Configure a filter to drop packets. seq Configure a drop or permit filter with a specified sequence number. seq c e s Syntax Parameters Defaults Command Modes Command History Assign a sequence number to a deny or permit filter in a prefix list while configuring the filter. seq sequence-number {deny | permit} {any} | [ip-prefix /nn {ge min-prefix-length} {le max-prefix-length}] | [bitmask number] sequence-number deny permit any ip-prefix /nn ge min-prefix-length le max-prefix-length bitmask number Enter a number. Range: 1 to 4294967294. Enter the keyword deny to configure a filter to drop packets meeting this condition. Enter the keyword permit to configure a filter to forward packets meeting this condition. (OPTIONAL) Enter the keyword any to match any packets. (OPTIONAL) Specify an IP prefix in the network/length format. For example, 35.0.0.0/8 means match the first 8 bits of address 35.0.0.0. (OPTIONAL) Enter the keyword ge followed by the minimum prefix length, which is a number from zero (0) to 32. (OPTIONAL) Enter the keyword le followed by the maximum prefix length, which is a number from zero (0) to 32. Enter the keyword bitmask followed by a bit mask number in dotted decimal format. Not configured. PREFIX-LIST Version 8.1.1.0 Version 7.6.1.0 Introduced on E-Series ExaScale Added support for S-Series Access Control Lists (ACL) | 255