Dell Force10 S4820T FTOS Command Reference Guide - Page 1148

www.dell.com | support.dell.com Defaults Command Modes Command History Usage Information Not configured CONFIGURATION Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.6.1.0 Introduced on S4820T Introduced on S4810 Introduced on C-Series and S-Series Introduced The access name is an extended IP access list that denies PIM register packets to RP at the source DR based on the multicast and group addresses. Do not enter this command before creating the access-list. ip pim rp-address c e s Configure a static PIM Rendezvous Point (RP) address for a group or access-list. Syntax Parameters Defaults Command Modes Command History ip pim rp-address address {group-address group-address mask} override To remove an RP address, use the no ip pim rp-address address {group-address group-address mask} override command. address group-address group-address mask override Enter the RP address in dotted decimal format (A.B.C.D). Enter the keyword group-address followed by a group-address mask, in dotted decimal format (/xx), to assign that group address to the RP. Enter the keyword override to override the BSR updates with static RP. The override will take effect immediately during enable/disable. Note: This option is applicable to multicast group range. Not configured CONFIGURATION Version 8.3.19.0 Version 8.3.7.0 Version 8.1.1.0 Version 7.8.1.0 pre-Version 6.1.1.1 Introduced on S4820T Introduced on S4810 Introduced on E-Series ExaScale Introduced on S-Series Introduced on E-Series 1148 | PIM-Sparse Mode (PIM-SM)