Dell Force10 S4820T FTOS Command Reference Guide - Page 1027

Parameters Defaults Command Modes Command History Usage Information Related Commands peer address connect-source interface description name sa-limit number Enter the peer address in a dotted decimal format (A.B.C.D.) (OPTIONAL) Enter the keyword connect-source followed by one of the interfaces and slot/port or number information: • For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For a Port Channel interface, enter the keyword port-channel followed by a number: E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. (OPTIONAL) Enter the keyword description followed by a description name (max 80 characters) to designate a description for the MSDP peer. (OPTIONAL) Enter the maximum number of SA entries in SA-cache. Range: 1 to 500000 Default: 500000 As above CONFIGURATION Version 8.3.19.0 Version 8.3.7.0 Version 8.5.1.0 Version 7.5.1.0 Version 6.2.1.1 Introduced on S4820T Introduced on S4810 Added support for 4-port 40G line cards on ExaScale. Added option for SA upper limit and description option Introduced The connect-source option is used to supply a source IP address for the TCP connection. When an interface is specified using the connect-source option, the primary configured address on the interface is used. If the total number of SA messages received from the peer is already larger than the limit when this command is applied, those SA messages will continue to be accepted. To enforce the limit in such situation, use command clear ip msdp peer command to reset the peer. ip msdp sa-limit clear ip msdp peer show ip msdp Configure the MSDP SA Limit Clear the MSDP peer. Display the MSDP information Multicast Source Discovery Protocol (MSDP) | 1027