Dell Force10 S4820T FTOS Command Reference Guide - Page 663
interface port-channel
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 663 highlights
Related Commands port-channel failover-group show interfaces port-channel Access the PORT-CHANNEL FAILOVER-GROUP mode to configure a LAG failover group. Display information on configured Port Channel groups. interface port-channel c e s Create a Port Channel interface, which is a link aggregation group containing up to 16 physical interfaces on E-Series, eight physical interfaces on C-Series and S-Series. Syntax interface port-channel channel-number To delete a Port Channel, use the no interface port-channel channel-number command. Parameters channel-number For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.0 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced for E-Series Example Usage Information FTOS(conf)#int port-channel 2 FTOS(conf-if-po-2)# Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by using the switchport command) or Layer 3 mode (by configuring an IP address). You can add a Port Channel in Layer 2 mode to a VLAN. The shutdown, description, and name commands are the only commands that you can configure on an interface while it is a member of a Port Channel. To add a physical interface to a Port Channel, the interface can only have the shutdown, description, and name commands configured. The Port Channel's configuration is applied to the interfaces within the Port Channel. A Port Channel can contain both 100/1000 interfaces and GE interfaces. Based on the first interface configured in the Port Channel and enabled, FTOS determines if the Port Channel uses 100 Mb/s or 1000 Mb/s as the common speed. Refer to channel-member for more information. Interfaces | 663