Dell Force10 S4820T FTOS Command Reference Guide - Page 660

www.dell.com | support.dell.com Table 23-10. Port Channel Limits Platform Maximum Port Channel IDs E-Series ExaScale 255 E-Series TeraScale 255 E-Series EtherScale 32 C-Series 128 S-Series 128 Maximum Members per Port Channel 64 16 16 8 8 Because each port can be assigned to only one Port Channel, and each Port Channel must have at least one port, some of those nominally available Port Channels might have no function because they could have no members if there are not enough ports installed. In the S-Series, those ports could be provided by stack members. The commands in this section are specific to Port Channel interfaces: • channel-member • group • interface port-channel • minimum-links • port-channel failover-group • show config • show interfaces port-channel • show port-channel-flow Note: The FTOS implementation of LAG or Port Channel requires that you configure a LAG on both switches manually. For information on FTOS Link Aggregation Control Protocol (LACP) for dynamic LAGs, refer to Link Aggregation Control Protocol (LACP). For more information on configuring and using Port Channels, refer to the FTOS Configuration Guide. channel-member c e s Add an interface to the Port Channel, while in the INTERFACE PORTCHANNEL mode. Syntax channel-member interface To delete an interface from a Port Channel, use the no channel-member interface command. 660 | Interfaces