Dell Force10 S4820T FTOS Command Reference Guide - Page 1236
is by default the same as, is Mbps unless
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1236 highlights
www.dell.com | support.dell.com Version 7.5.1.0 Introduced on C-Series pre-Version 6.1.1.1 Introduced on E-Series Related Commands rate limit Specify rate-limit functionality on the selected interface. qos-policy-output Create a QoS output policy. rate-police c e s Specify the policing functionality on incoming traffic. Syntax rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]] Parameters kbps committed-rate burst-KB peak peak-rate Enter this keyword to specify the rate limit in Kilobits per second (Kbps). On C-Series and S-Series make the following value a multiple of 64. On the E-Series, Force10 recommends using a value greater than or equal to 512 as lower values does not yield accurate results. The default granularity is Megabits per second (Mbps). Range: 0 to 40000000 Enter the committed rate in Mbps. Range: 0 to 10000 Mbps (OPTIONAL) Enter the burst size in KB. Range: 16 to 200000 KB Default: 50 KB (OPTIONAL) Enter the keyword peak followed by the peak rate in Mbps. Range: 0 to 10000 Mbps Default: Same as designated for committed-rate Defaults Burst size is 50 KB. peak-rate is by default the same as committed-rate. Granularity for committed-rate and peak-rate is Mbps unless the kbps option is used. Command Modes QOS-POLICY-IN Command History Version 8.3.19.0 Introduced on S4820T Version 8.3.7.0 Introduced on S4810 Version 8.2.1.0 Added kbps option on C-Series, E-Series, and Series. Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series pre-Version 6.1.1.1 Introduced on E-Series Related Commands rate police qos-policy-input Specify traffic policing on the selected interface. Create a QoS output policy. 1236 | Quality of Service (QoS)