Dell Force10 S4820T FTOS Command Reference Guide - Page 940
show isis database
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 940 highlights
www.dell.com | support.dell.com Examples Figure 29-2. Command Example: show config (router-isis mode) FTOS(conf-router_isis)#show config ! router isis clns host ISIS 49.0000.0001.F100.E120.0013.00 log-adjacency-changes net 49.0000.0001.F100.E120.0013.00 ! address-family ipv6 unicast maximum-paths 16 multi-topology transition set-overload-bit spf-interval level-1 100 15 20 Identifies that Multi-Topology IS-IS is enabled in transition mode spf-interval level-2 120 20 25 exit-address-family Figure 29-3. Command Example: show config (address-family-ipv6 mode) FTOS(conf-router_isis-af_ipv6)#show conf ! address-family ipv6 unicast maximum-paths 16 Identifies that Multi-Topology multi-topology transition set-overload-bit spf-interval level-1 100 15 20 IS-IS is enabled in transition mode spf-interval level-2 120 20 25 exit-address-family show isis database e Display the IS-IS link state database. Syntax show isis database [level-1 | level-2] [local] [detail | summary] [lspid] Parameters level-1 level-2 local detail summary lspid (OPTIONAL) Displays the Level 1 IS-IS link-state database. (OPTIONAL) Displays the Level 2 IS-IS link-state database. (OPTIONAL) Displays local link-state database information. (OPTIONAL) Detailed link-state database information of each LSP displays when specified. If not specified, a summary displays. (OPTIONAL) Summary of link-state database information displays when specified. (OPTIONAL) Display only the specified LSP. Command Modes EXEC EXEC Privilege 940 | Intermediate System to Intermediate System (IS-IS)