Dell Force10 S4820T FTOS Command Reference Guide - Page 1059

Usage Information Static mroutes are used by network administrators to control the reach-ability of the multicast sources. If a PIM registered multicast source is reachable via static mroute as well as unicast route, the distance of each route is examined and the route with shorter distance is the one the PIM selects for reach-ability. Example Note: The default distance of mroutes is zero (0) and is CLI configurable on a per route basis. FTOS#show ip rpf RPF information for 10.10.10.9 RPF interface: Gi 3/4 RPF neighbor: 165.87.31.4 RPF route/mask: 10.10.10.9/255.255.255.255 RPF type: unicast show queue backplane multicast e Display the backplane bandwidth configuration about how much bandwidth is dedicated to multicast versus unicast. Syntax Defaults show queue backplane multicast bandwidth-percentage None Command Modes EXEC EXEC Privilege Command History Example Related Commands Version 7.7.1.0 Introduced on E-Series FTOS#show queue backplane multicast bandwidth-percent Configured multicast bandwidth percentage is 80 queue backplane multicast Reallocate the amount of bandwidth dedicated to multicast traffic. IPv6 Multicast Commands IPv6 Multicast commands are: • clear ipv6 mroute • debug ipv6 mld_host • ipv6 multicast-limit • ip multicast-limit • show ipv6 mroute • show ipv6 mroute mld • show ipv6 mroute summary Multicast | 1059