Dell Force10 S4820T FTOS Command Reference Guide - Page 485

To remove the configured priority schedule, use the no scheduler command. Parameters value Enter schedule priority value. Range: strict: strict priority traffic is serviced before any other queued traffic. Defaults WERR scheduling is used to queue priority traffic. Command Modes POLICY-MAP-OUT-ETS Command History Version 8.3.19.0 Version 8.3.12.0 Version 8.3.16.0 Introduced on the S4820T. Introduced on the S4810. Introduced on MXL 10/40GbE Switch IO Module Usage dot1p priority traffic on the switch is scheduled to the current queue mapping. dot1p priorities within Information the same queue should have the same traffic properties and scheduling method. ETS-assigned scheduling applies only to data queues, not to control queues. The configuration of bandwidth allocation and strict-queue scheduling is not supported at the same time for a priority group. If both are configured, the configured bandwidth allocation will be ignored for priority-group traffic when you apply the output policy on an interface. Related Commands qos-policy-output ets bandwidth-percentage Configure the ETS bandwidth allocation. Bandwidth percentage allocated to priority traffic in port queues. set-pgid Configure the priority-group identifier. Syntax set-pgid value To remove the priority group, use the no set-pgid command. Parameters value Enter the priority group identification. Range: 0 to 7. Defaults none Command Modes PRIORITY-GROUP Command History Version 8.3.19.0 Version 8.3.12.0 Version 8.3.16.0 Introduced on the S4820T. Introduced on the S4810. Introduced on MXL 10/40GbE Switch IO Module Data Center Bridging | 485