Dell Force10 S4820T FTOS Command Reference Guide - Page 587

Syntax Parameters Defaults Command Modes Command History Usage Information ip igmp static-group {group address [exclude [source address]] | [include {source address}]} To delete a static address, use the no ip igmp static-group {group address [exclude [source address]] | [include {source address}]} command. group address exclude source address include source address Enter the group address in dotted decimal format (A.B.C.D) (OPTIONAL) Enter the keyword exclude followed by the source address, in dotted decimal format (A.B.C.D), for which a static entry needs to be added. (OPTIONAL) Enter the keyword include followed by the source address, in dotted decimal format (A.B.C.D), for which a static entry needs to be added. Note: A group in include mode must have at least one source address defined. No default values or behavior INTERFACE Version 8.3.19.0 Introduced on S4820T Version 8.3.7.0 Introduced on S4810 Version 7.8.1.0 Introduced on S-Series Version 7.7.1.0 Introduced on C-Series Version 7.5.1.0 Expanded to support the exclude and include options E-Series legacy command A group in the include mode should have at least one source address defined. In exclude mode if no source address is specified, FTOS implicitly assumes all sources are included. If neither include or exclude is specified, FTOS implicitly assumes a IGMPv2 static join. Related Commands Command Limitations • Only one mode (include or exclude) is permitted per multicast group per interface. To configure another mode, all sources belonging to the original mode must be unconfigured. • If a static configuration is present and a packet for the same group arrives on an interface, the dynamic entry will completely overwrite all the static configuration for the group. show ip igmp groups Display IGMP group information ip igmp version c e s Manually set the version of the router to IGMPv2 or IGMPv3. Internet Group Management Protocol (IGMP) | 587