Dell Force10 S4820T FTOS Command Reference Guide - Page 597

Usage Information FTOS provides the capability of statically configuring interface to which a multicast router is attached. To configure a static connection to the multicast router, enter the ip igmp snooping mrouter interface command in the VLAN context. The interface to the router must be a part of the VLAN where you are entering the command. ip igmp snooping querier c e s Enable IGMP querier processing for the VLAN interface. Syntax Defaults Command Modes Command History Usage Information ip igmp snooping querier To disable IGMP querier processing for the VLAN interface, enter no ip igmp snooping querier command. Not configured INTERFACE VLAN - (conf-if-vl-n) Version 8.3.19.0 Introduced on S4820T Version 8.3.7.0 Introduced on S4810 Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series legacy command This command enables the IGMP switch to send General Queries periodically. This is useful when there is no multicast router present in the VLAN because the multicast traffic does not need to be routed. An IP address must be assigned to the VLAN interface for the switch to act as a querier for this VLAN. show ip igmp snooping mrouter c e s Display multicast router interfaces. Syntax Parameters Command Modes show ip igmp snooping mrouter [vlan number] vlan number Enter the keyword vlan followed by the vlan number. Range: 1 to 4094 EXEC EXEC Privilege Internet Group Management Protocol (IGMP) | 597