Dell Force10 S4820T FTOS Command Reference Guide - Page 294

www.dell.com | support.dell.com Defaults Command Modes Command History Usage Information interface mode count number Enter one of the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword tengigabitethernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a port-channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1 to 128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale, and 1 to 512 for ExaScale. • For VLAN interfaces, enter the keyword vlan followed by a number from 1 to 4094. For ExaScale VLAN interfaces, the range is 1 to 2730 (VLAN IDs can be 0 to 4093). (OPTIONAL) Enter one of the following debug transmission modes: • Enter the keyword both to display information for both received and sent packets. • Enter the keyword rx to display information for received packets. • Enter the keyword tx to display information for sent packets. Default: both (OPTIONAL) Enter this keyword followed by the number of debug messages to display. Range: 1 to 65534 Default: Infinite-that is, if a count number is not specified an infinite number of debug messages will display. Disabled EXEC Privilege Version 8.2.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 Introduced on E-Series ExaScale Introduced on C-Series Added support for VLAN and port-channel interfaces on E-Series Introduced on E-Series Since BFD can potentially transmit 20 packets per interface, debugging information should be restricted. ip route bfd c e Syntax Enable BFD for all neighbors configured through static routes. ip route bfd [interval interval min_rx min_rx multiplier value role {active | passive}] 294 | Bidirectional Forwarding Detection (BFD)